17mm Single-Sided FET Driver PCB - V1.13 - MTN-17DD - 1.2mm or 1.6mm

17mm Single-Sided FET Driver PCB - V1.13 - MTN-17DD - 1.2mm or 1.6mm
17mm Single-Sided FET Driver PCB - V1.13 - MTN-17DD - 1.2mm or 1.6mm
Product Code: MTN17DD-PCB-V1.13
Availability: 2
Price: $0.65
Qty:     - OR -   Add to Wish List
Add to Compare

This is the bare PCB you need to build your own 17mm FET driver!  DIY parts kit available here.

This PCB is 1.2mm or 1.6mm thick with heavy 2 oz. copper and red solder resist.  Same parts as most previous MTN-17DD drivers.

Parts Required:

  • FET: LFPAK56 N-Channel Mosfet
  • D1:  SOD-323 Schottky diode
  • C1:  10uF MLC capacitor, 0805 (X7R preferred)
    • Populate CZNR instead of C1 if used zener modified
  • R1:  19.1K, 1% resistor, 0805
    • Use 36K 1% 0805 resistor for 2S or 3S zener mod LVP
  • R2:  4.7K, 1% resistor, 0805
  • UI:  ATTINY13A MCU, SSH or SSU variant
  • Z: SOD-323 4.3-5.1v zener diode
    • If zener diode is used:
      • populate CZNR instead of C1 with 10uF capacitor
      • replace D1 with 200 ohm resistor
  • Spring / LED leads
  • OTC:  1uF MLC capacitor, 0805 (X7R preferred)
    • Pad with side closest to MCU can also be used as electronic switch pad (no OTC installed).

The layout is the same for both 17mm and 20mm FET only boards.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



© Mountain Electronics LLC International Store